Design Process
Below will document the design process of ABC's Group Project including; building, testing, and prototyping.
|
A picture of the 400mAh battery charger. As well as the 400mAh battery that will power the shoe strap.
|
|
This is a picture of the laser cut 3D chassis. That will house all of the cars electrical components. |
|
Chassis before and after a few electrical components. The battery box, nodeMCU and a switch. All wired up
|
|
3D printed Box to house all the components for the Left and Right gloves and for the force sensor.
|
|
A few images of body being printed along with the Autodesk Fusion 360 images
|
|
second iteration of the gloves for Turning along with new copper tape plates and a image of the wiring harness to connect the Left and Right gloves and the force sensor together.
|
|
Updated new and improved car as the old body was way to heavy
|
|
1st Image of the controller harness
2nd Image of the inside of the gear box controller 3rd Image of the clear acrylic lid 4th the gloves with wires and copper tape 5th Image of the force sensor wired into the foot strap |